Knowledgebase: Audio Interfaces
Monitoring the audio recorded in your DAW software using the Helix Board
Posted by Rick Shao on 16 November 2015 06:29 AM
  1. Disengage all solo buttons on the Helix Board and make sure the solo indicator beside the main level meter is not lit up.
  2. Press the FireWire button in the control room source section.
  3. Plug your headphones into the Phones output jack and adjust the control room volume control to the appropriate position.
  4. Activate the channel you want to listen tos monitor button in your DAW software.
(1 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
Help Desk by Phonic