Knowledgebase: Audio Interfaces
I have the Firefly 302 Plus connected to the computer, however there's no power. Whats wrong?
Posted by Rick Shao on 16 November 2015 07:48 AM

First off, make sure you used the 6-pin connector to connect to your computer. Next, make sure the power select switch at the back of the unit is set to BUS. This will allow the Firefly to be powered through the FireWire interface. Alternatively, you could connect a suitable DC power supply to the unit and change the power select switch to DC IN.

(1 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
Help Desk by Phonic