Knowledgebase: Mixers
Is it possible to connect 4 speakers to my Roadgear 260?
Posted by Rick Shao on 13 November 2015 01:43 AM

When connecting 4 speakers to the RoadGear, the total loading for each power amplifier channel should not be lower than 4 ohms. Therefore, the impedance of each speaker should be 8 ohms or greater. The two RoadGear speakers can be used in this case, as well as 2 other 8 ohm speakers. As for sound quality, of course the signal sent to each speaker will be slightly diminished, however the clarity should not be affected at all. If anything, with the output of four speakers, the sound quality improves slightly.

(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
Help Desk by Phonic