Knowledgebase: Mixers
Monitor tracks individually on an MU or AM mixer in a live mix session?
Posted by Rick Shao on 13 November 2015 01:44 AM

Follow the instructions below to hear individual input channels through your headphones or control room monitors. Depending on your model, however, these steps may vary slightly.

  1. Set the EFX send and channel level controls to an appropriate level.
  2. Press the EFX CUE button (located above the CTRL RM volume control), and you will hear the channels signal through the EFX send.

Note: Because the EFX send is affected by each channels level control, you have to turn the level control to the appropriate setting in order to hear channel signal through the EFX send. When multiple channels are in use, simply set one EFX send level controls to an appropriate setting, and turn the remaining channels EFX send level control to the far left, then you will only hear the channel on headphones through EFX CUE button.

(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
Help Desk by Phonic